A wooden fence installation is not difficult, nor is it complicated. A little know-how and a few tools from affordable fencing company will help you create a beautiful fence. This article outlines the basics of wooden fence installation. Let’s start with a short list of basic tools. Have enough material to complete your project. If you stop the work at any point, it can affect the final product.
Check out this Tool List
Boards & Posts
Power Saw
Post Hole Digger
Paint or Outdoor Stain
Steel Tape
Marking Pencil
Small Axe or a Hatchet
Gravel or sand
Nails
Hand Saw
Hammer
Work Gloves
It is a level of difficulty.
Ready-Mix Concrete
Wood Chisel
Tamping Rod
Wood Preservative
Plumb bob
You may not find this list exhaustive depending on how intricate your design is. If you want to move the material, use a small-sized tractor or cement mixer to create the hole, to level your site and to make it easier to work with, as well as to help dig out the post holes. A professional fence company can help you if there is ever a time when you feel uncomfortable. If you want a fence to last, it is important to do the job right. To reach the desired fence height, posts must be tall enough that they can still be sunk in the ground 24-30″.
Step 1: A rough survey
Finding the pins for the boundaries and laying out the fenceline with string is the first step to a successful fence installation. Then, determine the position of the posts. Place the posts at six to eight foot intervals (measured in relation to the centre of the post), starting from the corners. Next, you need to measure the gate or obstacle you are going to encounter.
Step 2: Installing the posts
When building your first fence, it is best to begin at the far end. This will allow you to more easily hide any imperfections. Check the location of each post for rocks or stumps that may hinder construction. The post holes are ready. You should dig as you go, because unset holes can fill with water and collapse if the weather turns bad. Keep the hole vertical. Follow the manufacturers instructions when mixing the concrete. Some scrap wood will be needed to support the post as the concrete cures. The first posts and corners are the most important, since this will be where the line is centered. Pour about two to three inch of gravel on the bottom. This allows for drainage and will prevent the posts from rotting. Placing the post carefully into the hole will prevent it from collapsing. Attach two braces opposite each other and the plumbbob on the top where the post will hang. Pour concrete only after the post is square along all three axes. As soon as the concrete is set, you can confirm that the post is in the right place. Then, dig your next hole. Build up the concrete to a high mound, so that the water will drain away. The concrete should be allowed to dry overnight.
Step 3: Installing rails and Slats
When the concrete has completely set, you can remove the bracing. Check that the post was positioned properly. Install the rails at an angle (preferably the face this time), using either a wooden block, metal bracket or screw. As you work, be sure to keep checking the position of the posts as well as the height of the rails. If you want to keep the fence from rotting, make sure to leave 2″ of space at the bottom.